Product Page: DCS-5610   Firmware Version: 1.00
Live Video Setup Maintenance Status Help


DI and DO

The I/O connector provides the physical interface for digital output (DO) and digital input (DI) that is used for connecting a diversity of external alarm devices to the PTZ IP camera such as IR-Sensors and alarm relays.

The digital input is used for connecting external alarm devices and once triggered images will be taken and e-mailed.

DI and DO

Digital input: The active state is ; the current state detected is Low

Digital output: The active state is ; the current state detected is Grounded
Helpful Hints..

The IP camera provides a general I/O terminal block with one digital input and one relay switch for device control. Pin 1 and pin2 can be connected to an external sensor and the state of voltage will be monitored from the initial state ‘LOW’. The relay switch of pin 3 and pin 4 can be used to turn on or off the external device.Please refer to manual for detail connection diagram.


Copyright © 2008 D-Link Corporation/D-Link Systems, Inc. All rights reserved.